The DJL lamp is one of the most widely used lamps found in vintage movie film projectors. Some of the best quality 8mm and Super8 projectors ever made, especially those by Bell & Howell and Sears used DJL lamps. The last few years the DJL lamp has become increasingly hard to get, and the prices have skyrocketed. We have come up with a more reliable, much lower cost solution. With just a few tools, you can replace that Bat Crap Crazy Expensive DJL lamp with our easy to install DJL replacement lamp module!!! IF YOU CAN DRILL 2 HOLES, STRIP AND WIRENUT 2 WIRES YOU CAN SAVE $$$$ BIG TIME!!! This module will fit on all DJL projectors we know of, including all vintage Bell & Howell models. The module comes with a simple set of instructions and 3 minute DVD to guide you through. It can be done in 10-15 minutes. The tools required are hammer, punch, drill, wire strippers, screw / nut drive. The kit comes with housing, lamp, screws, wire nuts, instruction sheet, and DVD. Copy and paste this number into any eBay search box and you can order this lamp module from there; 251172875137 Once the lamp housing is installed, and should the lamp ever need to be replaced, it simply pops out with a gentle pull on the lamp housing lever. These replacement lamps can be found in the DJL lamp listings or in our store on the eBay site. The cost is just 25.00, so you can see the savings is significant! This way too, you can keep using the old family projector!